An easy way to personalize your home’s interior design. After trying it out, everything looks like new
If you are tired of anonymous white walls, but this is not the case neither desire nor time to sugarcoat it With a new paint there is a very practical method without the risk of dirtying the house and changing the look of your home. Not only is it the perfect solution for those who cannot devote themselves to this type of activity for too long.
But it is suitable for more modern environments as well as others You can give it a creative touch, and the classic ones, where you opt for a more traditional style. Here’s how to intervene and which method is best to avoid errors.
How to decorate your home with wallpaper: Here’s how to do it
AND with wallpaper that the house quickly changes its appearance, gives you new emotions and makes the rooms appear in a new light. Many think that the application is a complex and lengthy process: in reality, it is enough to follow a few simple rules and the result will be an accurate application in a very short time. The first step is to remove the old wallpaper, if there is any, using special adhesive products or, if it is whitewashed, to sand off the old paint so that the glue sticks better. In any case, the surface must be clean and free of traces of moisture, which may need to be treated before applying the fixative, with a roller.
The wallpaper is suitable for both classic and modern environments (designmag.it)
After removing switches and outlets, you can Mix wallpaper glue Follow the instructions and then use a tape measure and plumb bob to draw the reference marks on the wall. If there is a pattern on the wallpaper, in addition to paying attention to the characters on the wall, you also need to make sure that the motifs match each other. The suggestion is to cut the panel from top to bottom and proceed with the installation gradually. Of course, before attaching them, you must spread the glue on the wall, making sure to apply it only lightly beyond the width of the paper being laid.
Laying the sheets and removing excess edges
The first sheet is laid leave a higher surplus of a few centimeters and follows the previously drawn lines. The reference lines are then traced by lowering the plumb line on the wall so that the sheet matches the new trace. Essentially, the film will spill over onto nearby walls; At this point we always start gluing from the middle and move towards the ends to allow the remaining air to pass through the use of a stiff spatula or an upholstery brush. Only now can the excess be removed with a cutter. After laying the second strip, it is important to run the rubber wallpaper roller and a damp sponge over the joint between the two wallpapers to remove the excess glue. The final phase is to make the other cuts on the inside and outside corners of the walls, working with the putty on the most difficult places, such as the horizontal corners. It is important to install the last panel, which overlaps the previous panel that has already been glued and is then cut vertically at the overlap Remove the two cutouts.